Soldering Jig for RC Connectors

Soldering Jig for RC Connectors
Click To Enlarge
  • Item #: C-575

Would you like to make the task of soldering RC connectors simple and easy? If so, you've found the right piece of equipment! The Jigs Up Soldering Jig quickly and securely clamps, holds, and releases these connectors for your soldering tasks. 

Description:

---The Jigs Up holds the following connectors: XT60, T connector, Traxxas, EC-3, EC-5, Deans Micro 2pin, 3pin, & 4pin connectors and 2mm, 3.5mm, 4mm, 5mm, 5.5mm, 6mm, and 6.5mm bullet connectors.
---The holes on top of the jig are used to hold 3.5mm, 4mm, 5mm, 5.5mm, 6mm and 6.5 mm bullet connectors.---The “V” slots on the front of the jig are used to hold the 2mm bullet connectors and the pins for the Traxxas connectors.
---The slot on the right side of the jig is used for a XT60 connector, Traxxas and the T connectors.
--- The slot on the left side of the jig is used for Deans 2-pin, 3-pin, and 4-pin micro connectors.
--- The included alligator clips expand your options for gripping small parts or wire for soldering.
--- The 'helping hand' makes it easy to hold wires in place while soldering.
--- The phenolic resin insert helps to dissipate heat.


The video clip shows how to solder a T Connector, a 3.5mm bullet connector, and a 2mm bullet connector.

 

******To start out, make sure that your soldering iron is HOT!!!!

 

We recommend that you tin both the wire and the connector pin to be soldered with a liberal amount of solder.

 

Now place the wire on top of the connector pin and place the “hot” soldering tip on top of the wire until the solder melts…

 

Then take the soldering tip away from the wire and hold the wire in place for a few seconds until the solder cools……..

 

This will give you a good connection!

HOT TIP FOR SOLDERING BULLET CONNECTORS:

You can achieve excellent results quickly and easily soldering bullet connectors with The Jigs Up if you use one of the following methods.  Method #1, you can use a soldering tip with a 60 degree cone (conical) shaped tip. Insert the hot soldering tip into the vent hole found on the side of many bullet connector cups and fill the cup about 1/4 full with hot melted solder, now insert the tinned wire to be soldered all the way down into the cup.  Remove the soldering tip from the connector cup and continue to hold the wire for a few seconds until the solder hardens.  Method #2, you can also get excellent results quickly and easily if you use a hot 1/4" wide spade (screwdriver, chisel) shaped soldering tip put to the side of the connector cup (covering the vent hole if there is one) and filling the cup about 1/4 full with hot melted solder and inserting the tinned wire to be soldered all the way down into the connector cup, then remove the soldering tip from the side of the connector cup and continue to hold the wire until the solder hardens. These methods darn near eliminate solder from flowing down onto the sides and splines of male and female bullet connectors resulting in a quick, simple and easy professional soldering job.  Hope this helps you...

  * Marked fields are required.
Qty*
Price $29.95
Availability In-Stock
# Available 2