Shopping Cart

0 item(s) in cart/ total: $0    view cart
Easy Star I Adjustable Motor Mount

Easy Star I Adjustable Motor Mount

Your Price: $15.95
In Stock.4
Part Number:D-241

*Please note, this mount is compatible with the original Multiplex Easy Star I, but not with the Easy Star II.  A separate adjustable mount for the Easy Star II is available at the following link:  East Star II Adjustable Motor Mount (SKU # A-126)



Compatible Motors:

  • 28mm Outrunners
  • 35mm Outrunners
  • Power Up 400 series motors
  • Power Up 450 series motors
  • Acceptable bolt patterns shown below

Due to the large variety of compatible motors, please verify motor size and KV that will suit your flying style

Acceptable bolt patterns (units in mm):
16x16, 16x19, 19x19, 19x25, 25x25

This CNC machined aluminum two piece mount is designed to adapt a large range of outrunner motors to the Multiplex Easy Star. It will allow for three different motor mounting heights to accommodate propeller sizes ranging from 6" to 8".

With this feature you can easily run a lower KV motor with a larger propeller for more thrust and better efficiency. This would be a perfect combination for FPV pilots looking for longer flight times and a quieter platform.

Swapping motors from a 35mm outrunner with an 8" prop to a 28mm outrunner with a 6" prop can easily be done by removing a few screws. This is ideal for those looking to achieve the best performance possible.

Position 1: stock height up to a 6" prop.
Position 2: (+) 0.41" for up to a 7" prop.
Position 3: (+) 1.0" for up to an 8" prop.

Three step installation:

  1. Glue motor base tube into the fuselage (nacelle) making sure mounting flange is square.
  2. Attach new motor to motor plate with supplied flat head screws.
  3. Attach motor plate to motor tube at desired height with supplied pan head screws.

Included: 1 - Motor Base Tube and Motor Plate, 4 motor screws and 4 mount screws.

Total Weight: 20g

Notes: A 35mm outrunner motor will only fit in Position 3 (+ 1.0"). 28mm outrunners will work in any of the three positions. The stock thrust angles are retained in all 3 positions. If a change in thrust angle is desired, simply add a small washer between the motor base and motor plate at the appropriate locations.

Dimensions: I.D. = 1.01" / O.D. = 1.11" / Length: 1.375"

The Center of Gravity of your model should always be checked and adjusted per the user manual after installation of a new motor.

Reward Points

10 points will be rewarded to you when you buy this item.

Related Items

Recently Viewed Items